Freepbx Install Unistim Nortel

After nearly 2 weeks of trying to research this and try different configurations I finally have to break down and ask for help. I am new to Asterisk and I am trying to setup and test run some i2004 phones that I purchased used. I am now back to square one with a completely fresh install of AsteriskNOW 1.7.1 (Asterisk 1.6.2.11 and FreePBX 2.7.0.0).

Hi all Looking for help with using a Unistim Nortel i2004 black with Asterisk (Ver. 11.21.0) Elastix and FreePbx. I have been able to register the phone OK to t. I’ve had no luck making it work with the FreePBX distro. I just kept a Elastix 2.5 install dedicated to handle legacy UNISTIM 2002’s trunked to our main system.

I have read the other posts about configuring the i2004 phones for Asterisk however I am still getting the same results on the display of the i2004 phones every time. ¨Server Unreachable¨ I have these i2004s connected to a Baystack 460 running on PoE. I have pinged the phone and it comes back fine. I have pinged the server and it comes back fine. Any help would be much appreciated.

Hi hrpty and welcome to the forums! The i2004 and i2002 are almost identical so I would advise you check out this article I wrote a few years back. You need to use the UNIStim channel driver (hopefully it's still in Asterisk) since these IP phones are not capable of SIP. You also didn't mentioned that you configured the IP phones with the IP address and port of the Asterisk server. First Choice Dos Program Download more. You should be able to run Asterisk in debug mode (or perform a packet capture from the server) to see the IP phones attempting to connect. I have read this thoroughly and everywhere is stated that Asterisk v1. Extreme Makeover Home Edition Gilbert Arizona. 6 and up come with Unistim in the Asterisk tree source.