Installing A New Bathtub
Edit Article How to Install a Bathtub. Four Parts: Measuring the Bathroom Space Removing the Old Bathtub Preparing to Install the New Bathtub Securing the Tub. • Rest a level atop each of the four sides of the bathtub to check for a plumb installation. • If necessary, add shims beneath the tub. Use a level on all four sides of the tub to check for a plumb installation. Install the rubber gasket on the bathtub overflow tube, and attach it to the tub (Image 2). Use the fittings provided to attach the stopper retaining bracket (Image 3). Apply a ring of plumber's putty around the drain flange (Image 4). Attach the drain to the bathtub, using screws to secure it in place (Image 5). • Rest a level atop each of the four sides of the bathtub to check for a plumb installation. • If necessary, add shims beneath the tub. Use a level on all four sides of the tub to.
Before you begin, make sure you have enough room to fit the bathtub through the doorway. Turn off the water supply. After the water has been turned off, open a faucet below the tub level to drain the water supply lines.
Remove the faucet, the drain, and the spout. Disk Image Mounter Download. If your bathtub is sandwiched between two walls, with the faucet and shower head located on one wall, you may be able to disconnect the piping and then pull the tub out. If this doesn’t work, you may have to remove a section of the wall around the bathtub, cut the piping, and remove the bathtub through the wall. If your bathtub is freestanding, removal is somewhat easier. After disconnecting the piping, you should simply be able to lift the tub out.
Before installing a new bathtub, make sure that your selection is an exact fit into the old bathtub space. Make sure it is apron-styled or drop-in, and that the drain is on the same side, because bathtubs can have right-hand or left-hand drains. Fanaa Film Mp4 Video Download. If the bathtub is not an exact fit, the piping will have to be modified for the new bathtub.
/155068606-56a4a2985f9b58b7d0d7ef19.jpg)
If it is an exact fit, you’ll follow the same steps for removing the old bathtub, just in reverse. You may need to repair the wall surface so it rests on the flange of the new tub. Always use cement backerboard under tiles in the bathtub or shower areas for moisture protection and to prevent a possible mold problem. 2020ja Premiumx Software Update on this page. Regular drywall is not rated to handle extreme moisture.